Carrier 50TCQA Installation Instructions Manual

Also see for 48TC*D: Service and maintenance instructions Installation instructions

Contents

4C09002Fig. 1 -- Unit Dimensional Drawing – 04 — 07 Size Unit (cont.)INSTALLATIONJobsite SurveyComplete the following checks before installation.1. Consult local building codes and the NEC (NationalElectrical Code) ANSI/NFPA 70 for special installa-tion requirements.2. Determine unit location (from project plans) or selectunit location.3. Check for possible overhead obstructions which mayinterfere with unit lifting or rigging.Step 1 — Plan for Unit LocationSelect a location for the unit and its support system (curbor other) that provides for the minimum clearancesrequired for safety. This includes the clearance tocombustible surfaces, unit performance and service accessbelow, around and above unit as specified in unitdrawings. See Fig. 2.NOTE: Consider also the effect of adjacent units.Unit may be installed directly on wood flooring or on ClassA, B, or C roof--covering material when roof curb is used.Do not install unit in an indoor location. Do not locate airinlets near exhaust vents or other sources of contaminatedair.18” (457)42" (1067)18" (457)42" (1067)1Required bottom condensate drain connection.Otherwise, 36” (914mm) for condensate connection.1C07459Fig. 2 -- Service Clearance Dimensional DrawingAlthough unit is weatherproof, avoid locations that permitwater from higher level runoff and overhangs to fall ontothe unit.Select a unit mounting system that provides adequateheight to allow for removal and disposal of frost and icethat will form durring the heating--defrost mode as well asallow installation of condensate trap per requirements.Refer to Step 9 — Install External Condensate Trap andLine – for required trap dimensions.50TCQA