Carrier WeatherMaker 50TCQ07 Installation Instructions Manual

Also see for WeatherMaker 50TCQ*07: Product data

12Fig. 10 — Location of NotchesFig. 11 — Horizontal Duct Panels In PlaceStep 8 — Install Outside Air HoodECONOMIZER AND TWO-POSITION DAMPER HOODPACKAGE REMOVAL AND SETUP - FACTORY OPTION1. The hood is shipped in knock-down form and must befield assembled. The indoor coil access panel is used asthe hood top while the hood sides, divider and filter arepackaged together, attached to a metal support tray usingplastic stretch wrap, and shipped in the return air compart-ment behind the indoor coil access panel. The hood assem-bly’s metal tray is attached to the basepan and alsoattached to the damper using two plastic tie-wraps.2. To gain access to the hood, remove the filter access panel.(See Fig. 12.)Fig. 12 — Typical Access Panel Locations3. Locate the (2) screws holding the metal tray to the basepanand remove. Locate and cut the (2) plastic tie-wraps secur-ing the assembly to the damper (see Fig. 13). Be careful tonot damage any wiring or cut tie-wraps securing any wiring.Fig. 13 — Economizer and Two-Position DamperHood Parts Location4. Carefully lift the hood assembly (with metal tray) throughthe filter access opening and assemble per the steps outlinedin “Economizer Hood and Two-Position Hood” section.ECONOMIZER HOOD AND TWO-POSITION HOODNOTE: If the power exhaust accessory is to be installed on theunit, the hood shipped with the unit will not be used and must bediscarded. Save the aluminum filter for use in the power exhausthood assembly.1. The indoor coil access panel will be used as the top of thehood. Remove the screws along the sides and bottom ofthe indoor coil access panel. See Fig. 14.BASEPANNOTCHES NOTCHESSCREWSDUCT COVERSSHEET METALFACE UPBASEPANFILTER ACCESS PANELOUTDOOR-AIR OPENING ANDINDOOR COIL ACCESS PANELCOMPRESSORACCESS PANELHood PartsPlastic Tie WrapQty (2)Screws for Metal TrayQty (2)