Casio Privia PX-S3000 User Manual

Also see for Privia PX-S3000: Manual Connection guide

Contents

Casio Privia PX-S3000 User Manual Manual pdf 14 page image

EN-13Operations Common to All Modes■ Touch Button Light Auto OffTo save power, you can configure a setting that will turn off allbutton lights, except for the 3 mode selector button, after acertain period of non-operation. Use FUNCTION parameter102 (“Panel Light”) to specify the amount of non-operationtime (in seconds) until lights turn off, or you can specify thatlights should remain lit (initial default). For information aboutFUNCTION parameters, see “Configuring Function Settings(FUNCTION Mode)” (page EN-53).• To turn the touch button lights back on, touch the 3 Modeselector button.• Turning on the Digital Piano under battery power only(without AC adaptor power) will cause the Panel LightSetting to change automatically to 60 seconds to conservepower. You can change the Panel Light Setting if you want.• Turning off the Digital Piano, connecting the AC adaptor,and turning power back on will automatically cause “Off” tobe selected for the Panel Light Setting (if Auto Resume isdisabled).You can use the FUNCTION Mode menu to perform a widerange of Digital Piano setting operations. The example belowexplains how the selection of setting menu items (parameters)is presented in this manual.Example:1. Hold down the bp^ button until “[FUNCTION]”appears on the display.This enters the FUNCTION Mode.2. Use the bk U and bl I buttons to select thefollowing menu items in sequence:“KEYBOARD” 3 “Touch Response”.The actual operations performed in step 2 are those below.2-1. Use the bk U and bl I buttons to display“KEYBOARD” and then touch bm ENTER.2-2. Use the bk U and bl I buttons to display“Touch Response” and then touchbm ENTER.For details about the FUNCTION Menu configuration andoperations, see “Configuring Function Settings (FUNCTIONMode)” (page EN-53).• You can exit the FUNCTION Mode at any time by holdingdown bp EXIT until “[FUNCTION]” disappears from thedisplay.Use the procedure below when you need to change the nameof data saved on a USB flash drive or to input other text.■ To change a character1. Use the bk U and bl I buttons to move thecursor to the position of the character youwant to change, and then touch bm ENTER.This enters the character editing mode.2. Use the bk – and bl + buttons, or cm (K1)knob to change the currently selectedcharacter.3. To apply your edit, touch bm ENTER.This exits the character editing mode.FUNCTION Mode MenuOperations[F U N C T I O N]<S O U N D>Text Character Input[F U N C T I O N]–N o rma l+T o u c h R e spo n s e