2007020112-4-2Data Communications PrecautionsData Item Contents OverwriteCheck*1 Capture memory groupCAPT n Capture memory (1 to 20) data NoSETUP Setup data NoSYSTEMOS and data shared by applications (clipboard,replay, history, etc.), which is not included in theaboveNoAdd-in applicationnamesAdd-in application data(All add-in applications are listed.) No*1 No overwrite check: If the receiving unit already contains the same type of data, theexisting data is overwritten with the new data.With overwrite check: If the receiving unit already contains the same type of data, amessage appears to ask if the existing data should be overwritten with the new data.Data item name• 1(YES) ... {replaces the receiving unit’s existing data with the new data}• 6(NO) ... {skips to next data item}Note the following precautions whenever you perform data communications.• An error occurs whenever you try to send data to a receiving unit that is not yet standingby to receive data. When this happens, press J to clear the error and try again, aftersetting up the receiving unit to receive data.• An error occurs whenever the receiving unit does not receive any data approximately sixminutes after it is set up to receive data. When this happens, press J to clear the error.• An error occurs during data communications if the cable becomes disconnected, ifthe parameters of the two units do not match, or if any other communications problemoccurs. When this happens, press J to clear the error, then correct the problem beforetrying data communications again. If data communications are interrupted by the J keyoperation or an error, any data successfully received up to the interruption will be in thememory of the receiving unit.• An error occurs if the receiving unit memory becomes full during data communications.When this happens, press J to clear the error and delete unneeded data from thereceiving unit to make room for the new data, and then try again.
