Chapter 10 Other FunctionsSystem will ask users to make choice. Users can decide either use “manually set frameorigin” or “auto set frame origin”.Before setting the frame zero point manually, manually move the frame the desired originpoint position, and click the key. Then the system will save the current frame as the zero point.When meeting emergency stop because of malfunctions or something unusual such as poweroff unexpectedly, etc. the machine will cancel the “setting frame origin” function to avoid themistakes. So, at that time, you should do operation of “manually set frame origin” again at thelast frame zero point. If the frame has been moved after power off, or if power on again aftermaintenance, you should do again the operation of “manually set frame origin”.If you hope the system automatically set the frame origin point, click “Auto set frameorigin”, and the system will move the frame automatically and set the zero point according tothe limit switch. So please ensure that the limit switch has been installed into the machine andit’s effective.10.4 Frame Origin RecoveryAfter power off, if the frame is moved, this operation can be used to restore the frameposition when resume power. The proper performance of this operation is based on “Set FrameOrigin” (Auto set frame origin). In addition, when sudden power-off takes place in theprocess of embroidering operation and the frame has not been shifted, users can directly pullbar to continue embroidering after resuming power.1. Click in the main screen to enter the “Other functions” screen.BECS- A18/A58 computerized embroidery machine owner’s manual 95
