Chapter 12 Operation of Cording Embroidery3. Left Cording Device: Y (N) —— Y means the last needle is the cording embroideryposition.4. Cording Device Move Time: 1 (Default Value) —— User should set this valueaccording to the actual action time of the cording embroidery device.5. Swing Range of Cording Embroidery: 100 (Default Value), which is the rotatingangle of the wheel. In case of thread-floating, user can decrease this value to assist theadjustment. Generally, this value should be no less than 80.6. Top Speed of Cording Embroidery: 600 (Default Value). The top speed can be set ashigh as 1000 rpm, according to the actual condition of machine.7. Thread-loosing Motor for Cording Embroidery: Yes. If the cording device is ofdouble-motor type, user should set it as “Y”, otherwise “N”.8. Frame Swing of Z5 Embroidery: by adjusting the frame, user can change theembroidery range (advisable for senior users).9. Thread-loosing Adjustment Value for Cording Embroidery: this is to adjust thethread-sending speed of all the thread-loosing motors. The recommended value is 9.10. Origin of Right Cording Device: 0 (Default Value). This is for the angle between thethreading point and the direction of the mechanical origin of cording device at firstneedle position. Angle = Parameter value *0.9. For example, if the parameter value is30, the angle will be 30*0.9=27°.11. Origin of Left Cording Device: 0 (Default Value). This is for the angle between thethreading point and the direction of the mechanical origin of cording device at lastneedle position. Angle = Parameter value *0.9. For example, if the parameter value is30, the angle will be 30*0.9=27°.12. Cording Device Movement Detection: detect whether the device moves to the properposition. At present, this parameter is set as “N”.12.5 Relative Operations of Cording Embroidery12.5.1. Shift between Flat Embroidery Position and CordingEmbroidery Position1. Manual ShiftIn the main interface, click the key to enter into color-changing interface.124 BECS-A18/A58 computerized embroidery machine owner’s manual
