Chapter 11 D Type Sequin EmbroideryThis parameter is used to change the waiting time of the adjustment on action of intervalvalve. The larger the value is, the waiting time will be longer; the smaller the value is, thewaiting time will be shorter. User needs to adjust this value according to the actual condition ofthe sequin device. The default value of this parameter is 2.12. L/R Motor Shift Stroke Base.13. L/R Motor Shift Stroke Time.14. With Origin at L/R Motor Shift.The parameters No.8, No.9 and No.10 at above are for the special sequin device whichuses the motor of single needle dual-sequin device to shift the travel amounts of large sequinand small sequin. This kind of device contains two types: the one is with shift origin; the otheris without that shift origin.15. L/R Knife Start Angle Adj.This parameter is for the special sequin device using the motor to cut the sequin, whichcan adjust the start time of the sequin-cutting motor. The default value of this parameter is 15.The smaller this value is, the earlier the motor will be activated (Min value is 0); the larger thisvalue is, the later the motor will be activated (Max value is 31).16. Bead-breakage Detection Sensitivity.This parameter is for the beam embroidery device. “0” means to turn off the sensitivity ofthe beam-breakage detection. The range of this parameter is 0~10. “1” means the highestsensitivity, while “10” means the lowest sensitivity.11.6 Change Color Order and Set Sequin ModeUser must set sequin mode before setting color-changing toward normal multi-sequindesign, but expert multi-sequin design don’t need set multi-sequin sequin mode.Detailed operations are:116 BECS-A18/A58 computerized embroidery machine owner’s manual
