633.0 Operating the Unit3.0 Operating the Unit3.1 GPS Instructions3.1.1 Requirements:The WWAN module of the M9010 includes a GPS.3.1.2 Set up to use the GPSTo use the GPS, the WWAN module must be either fully turned on, orin airplane mode.To ensure WWAN is ON or in Airplane Mode:1. Open DAP Configuration Center2. Select the Power Options tab3. Ensure you are in one of the following combinations:• Global airplane mode is OFF and WWAN is ON or in AirplaneMode• Global airplane mode is ON and WWAN was either ON or inAirplane ModeHere are some acceptable settings:4. Open the GPS monitor (Fn + F6), and click on the ‘play’ button:You’ll get Session started, waiting for fix…5. To get more detailed information:a. Run Fastrax GPS Workbench available from the desktopb. Select File > Connect:6. Select Sierra Wireless NMEA Port (COM12), then OK. The fol-lowing screenshot shows 2 satellites are detected (not enough):Once the GPS is able to get a fix (enough satellites), Fastrax showssomething like:The GPS Monitor shows:7. Clicking on the third button shows a map.8. GPS is now ready.
