955.0 UPC Types5.14.1 Decode Event :Parameter # 0xF0 0x00When enabled, the decoder generates a message to the host whenever abar code is successfully decoded. When disabled, no notification is sent.5.14.2 Boot Up Event :Parameter # 0xF0 0x02When enabled, the decoder sends a message to the host whenever poweris applied. When disabled, no message is sent.*Disable(0x00)*Disable(0x00)Enable(0x01)Enable(0x01)5.14 Event ReportingThe host can request the decoder to furnish certain information (events)relative to the decoder’s behavior. Enable or disable the events listed inTable 8-2 by scanning the appropriate bar codes on the following pages.Parameter number format for these parameters follows those shown inTable 9-9 on page 9-20 for parameters numbered 256 or higher.Event Class Event Code ReportedDecode Event Non parameter decode 0x01Boot Up Event System power-up 0x03ParameterEventParameter entry errorParameter storedDefaults set (and parameterevent is enabled by default)Number expected0x070x080x0A0x0F5.14.3 Parameter Event :Parameter # 0xF0 0x03When enabled, the decoder sends a message to the host when one ofthe events specified in the table in Section 5.14 above occurs. Whendisabled, no message is sent.*Disable(0x00)Enable(0x01)5.15 Numeric Bar CodesFor parameters requiring specific numeric values, scan the appropri-ately numbered bar code(s).01234568795.15.1 CancelTo change the selection or cancel an incorrect entry, scan the bar codebelow.Cancel
