ES601Plus OPERATING MANUAL8.5.26 Printing AutoSequencesPress the Print button to show the print dialogue. Select the current sequence radio button and pressOK to print out the current AutoSequence. Select the All Sequences radio button and press OK toprint out all 24 AutoSequences. Pressing Cancel will close the print dialogue without printing.Return to Main MenuWhen edits have been completed, the user may return to the main menu of the ES601pc applicationby pressing this button. Remember, at this point, all changes that have been made have already beensaved.If the configuration that existed when entering the Editor may be required ata later time, be sure to Backup the configuration before making any edits.8.6 ECG AutoSequence Editor (standard accessory)In addition to an electrical safety analyzer, ES601Plus incorporates an electrocardiogram (ECG)simulator. The ECG Simulator of ES601Plus generates 40 different test signals the user can activatemanually using a menu system. In addition to the waveform, the amplitude of the output signal canbe set to one of three values: 1 mV (standard), 2 mV, or 0.5 mV (in Lead II).As an alternative to manually operating the simulator, the user can run an ECG AutoSequence inwhich ES601Plus can be stepped through a predetermined list of up to 24 selected waveforms ofgiven amplitudes. At each step of the ECG AutoSequence, the user can enter either a "PASS" or"FAIL”. At the end of the ECG AutoSequence, the user can optionally enter a comment of up to 40characters (e.g. "LEAD III NOT WORKING").ES601Plus provides 6 programmable ECG AutoSequences, each having from one to 24waveform/amplitude steps. ES601pc is used to select the waveforms and amplitudes for each stepof each ECG AutoSequence and program this setup into ES601Plus.Upon selecting ECG AUTOSEQUENCE EDITOR, you are taken to the editor screen (shown inFig u re 89).ES601pc Software/Chapter 8 # Page 153
