USING THE GRILLLIGHTING INSTRUCTIONSTO LIGHT THE GRILL BURNER:Open the grill lid before lighting. Turn all knobs to "OFF': Turn the main gas supply on slowly. If you smell gas, shut-offgas supply and call for service.Push and hold the ignition button, turn the selected burner knob to "HI". If burner does not light in 4 to 5seconds, turn knob "OFF" and wait 5 minutes before trying again for any accumulated gas to dissipate.Grill Match Lighting:If the burner will not light after several attempts then the burner can be match lit. If you've just attempted tolight the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. Keep your face as faraway from the grill as possible and hold and pass a lit, paper book match over the hole located on the top leftfor burner on the left, or the right hole for the right burner (Fig. 39 and Fig. 40). Push and turn the control knobwhich is centered on the burner where the lit match is located, to "HI". If the burner does not light in 4 seconds,turn the knob off, wait 5 minutes and try again.NOTE:Improper lighting procedures can cause the LP tankflow control to activate, resulting in reduced heat out-put. If this is suspected, to reset flow control, shut offall burner controls and LP cyfinder valve, wait 30 sec-onds, then turn LP cylinder valve on extremely slowly,wait five (5) seconds and push and hold the ignitionbutton and turn burner valve on to "HI': FIG. 39 FIG. 40Failure to follow the steps in the order shown may cause the FlowLimiting Device to activate resulting in extremely low gas flow andimproper operation.12All knobs must be in the OFF position beforeopening LP tank valve.Attach regulator hose assembly to tank.3 Now open the LP tank valve two (2) fullturns min.24