DCS RDT-305 Use And Care Manual

Also see for RDT-305: Installation guide Installation guide

DCS RDT-305 Use And Care Manual Manual pdf 7 page image

5n Be sure all the range and/or cooktop controls are turned off and the appliance is cool before using any type ofaerosol cleaner on or around the appliance. The chemical that produces the spraying action could, in the pres-ence of heat, ignite or cause metal parts to corrode.n Place oven racks in desired position while the oven is cool. If a rack must be moved while the oven is hot, do notlet the pot holders contact the hot interior of the oven.n Use care when opening the oven door; let hot air or steam escape before removing or replacing foods.n do not rub, damage, move or remove the door gasket. It is essential for a good seal during baking. Wash gasketwith hot water only.n Clean the ventilator hood and filters above the range or cooktop frequently so grease from cooking vapors doesnot accumulate on them. The filters can be cleaned in a dishwasher or dishdrawer. Follow directions providedby ventilation manufacturer for cleaning.n Turn the ventilator oFF in case of fire or when intentionally “flaming” liquor or other spirits on the cooktop. Theblower, if in operation, could unsafely spread the flames.n do NoT obstruct the flow of combustion or ventilation air to the appliance. Be sure a fresh air supply is available.n For safety reasons and to avoid damage to the appliance never sit, stand, or lean on the oven door or cookingsurface.n service should only be done by authorized technicians. Technicians must disconnect the power supply beforeservicing this appliance.WARNING!California proposition 65 - The burning of gas cooking fuel generates some by-products which are known by thestate of California to cause cancer or reproductive harm. California law requires businesses to warn customers of po-tential exposure to such substances. To minimize exposure to these substances, always operate this unit accordingto the instructions contained in this booklet and provide good ventilation to the room when cooking with gas.SAFETy PRACTICES AND PRECAUTIONSRECOMMENDATIONS ON HOOk-UP TO GAS SUPPLy:A manual valve must be installed external to the appliance, in an accessible location from the front for the pur-pose of shutting off the gas supply. The supply line must not protrude beyond the back of the unit. Make surethe gas supply is turned off at the wall valve before connecting the appliance.The gas supply connections should be made by a qualified technician and in accordance with local codes or ordi-nances. In the absence of a local code, the installation must conform to the latest edition of the National Fuel GasCode ANsI Z223.1.NOTE:This product must be installed by a licensedplumber or gas fitter when installed within theCommonwealth of Massachusetts.NOTE: (mandatory for the State ofMassachusetts) Alternate method of supplyinggas must be installed into the unit.Installer supplied shut-off valvemust be easily accessible insidecabinetry.Gas Supply