DELTA DORE CS 8000 TYXAL+ User Manual

Also see for CS 8000 TYXAL+: Quick installation guide User guide

DELTA DORE CS 8000 TYXAL+ User Manual Manual pdf 8 page image

EN- 15 -- 14 -OK1 2ou>2sSOS+1 2ou>2sSOSOK3.4 Override operation.ÊThe alarm control unit denies the activation.It emits a series of beeps to warn the user.On the remote control, the LED flashes red.Ë Confirm a second time by pressingON within 5 seconds after firstpressing the button.The LED changes from red to greento confirm the action.The alarm control unit emits a BEEP.3.5 Triggering of a discreet emergencyalarmPress and hold the 1 or 2 button for 2 seconds.The LED changes from red to green to confirm the action.- press OFF (deactivates the system).The telephone transmitter calls from the3rd number programmed. The 1st and 2nd numbers are notcalled for the discreet emergency alarm.3.6 Triggering of an emergency alarmwith sirenPress and hold the 1 or 2 button for 2 secondsto trigger:- a call cycle from the transmitter to the programmednumbers (starting with the 1st number).- an audible signal from an associated siren.The LED changes from red to greento confirm the action.Press OFF to stop an emergency alarm with siren in progress.For example, this function is used to activate the system evenif an entry remains open or if a product shows a defect (deadbattery, etc.).This function is used to trigger a discreet alarm with yourtelephone transmitter, without any aggressor being aware of it(no audible signal) whether the system is on or off.The 1 or 2 buttons must be configured in Mode B (seetable, § 3.1).This function is used to start a call with the telephonetransmitter to warn relatives that you are in a situation ofdistress. It also sets off the sirens with a specific tone.The 1 or 2 buttons must be configured in Mode C (seetable, § 3.1).ON 1 Activation denied (e.g.open entry)Beep, beep, beepON ON< 5sOK1 2Beep, beep, beep3. Use with the remote control3.7 Clearing defectsEach time the system is activated or deactivated, the alarmcontrol unit will inform you that an event (or defect) is stored byusing a series of beeps or a refusal to switch on.These events (intruder detection, product defect, open entry,etc.) can be cleared so as not to be signalled by the control unit.The system must be off.If you do not have a touch screen keypad, you canclear defects by using the remote control:Press and hold the OFF button for 5 seconds.The LED changes from red to green to confirm the action.The alarm control unit emits a series of beeps, stops, then emitsone more beep.3.8 Controlling a control systemMode D: Pulse controlPress the 1 or 2 button.The LED changes from red to green.Mode E: On/Off controlPress the 1 or 2 button then ON OFForON OFF .The LED changes from red to green.The 1 or 2 buttons must be configured in Mode D or E(see table § 3.1).OFF>5sBeep.Beep.Beep.....BeepONOnOffOFF1 2or1 2or< 2s< 2sExampleor1 2orExample