DW MEGAPIX User Manual

Contents

Setup Case C, DNetwork Setup -To connect the IP Camera directly to a modem, power downand reset the modem. Leave the modem powered down untilCamera has been connected correctly to the modem. Thenpower on the modem, followed by the IP Camera.Cable/xDSL Modem(ISP Provided)Phone Lineor CATVInternetInternetPublic Line Gateway orRouter at ISPSTATICNetwork Type :1.A static IP address received from your ISP suchas 24.107.88.125 (Example)Internet Address :2.You need to assign an IP address to the IP Camera just as you dowith PC.Subnet mask assigned from your ISP such as255.255.255.240 (Example)24.107.88.113 (Example)Subnet Mask :3.Default Gateway :4.Use the assigned default gateway from your ISPUse the 1st DNS Server from ‘Assigned IPAddress from My ISP’Preferred DNS Server :5.Use the DDNS serverDDNS Server :6.This is the same site you will register later to utilize our DDNSservice.80Web Port :7.You may select any number between 1025 ~ 60000.If you have not received any IP addresses from your ISP, contactthem to acquire the IP address of their DNS server.DYNAMICNetwork Type :1.Use the DDNS serverDDNS Server :2.This is the same site you will register later to accommodatedynamic IP from your ISP.80Web Port :3.You may select any number between 1025 ~ 60000.as follows :as follows :Case C:Static(Fixed) IP [Dedicated line directlyto the IP Camera]Case D:Dynamic IP + DSL/Cable Modem [Connecteddirectly to the IP Camera]CameraCamera