19OPERATION1. Insert the attached AC plug into a pronged 220V ACoutlet.AC Outletand PlugNOTES:• Never connect the AC line cord plug to other than thespecified voltage (220V).• Use the attached power cord only.• The new air conditioner system should be on it’s own220V circuit. Contact your local electrical installer for in-stallation.CONNECTING THE AC CORDThe outdoor unit is connected to the indoor unit through the AC connecting wire or connection cord. To connect the in-door unit to AC, follow the procedures below:Plug into 220V AC Outlet.1. Open the indoor unit’s cover and make sure theEMERGENCY/REMOTE switch is set to the RE-MOTE position; this will allow the unit to operate withthe remote controller.SETTING THE UNIT FOR REMOTE OPERATIONAfter the unit is fully connected and plugged in, it can be turned on. To turn the unit on and set it for remote operation,follow the procedures below:2. Press the ON/OFF button on the remote controller toturn on the unit. The On LED will light on the indoorunit and “ON” will light in the remote display.To select the various modes and settings, read thefollowing pages.EMR. REMOCONEMERGENCY/REMOTE SwitchTHREE MINUTE COMPRESSOR DELAY• After turning the indoor unit on and setting it for air con-ditioner operation, the compressor (outdoor unit) willnot come on for three minutes. This is a feature thatwill protect the compressor from damage due to quickstart and stops.