Daewoo DSB-071LH Owner's Manual

Also see for DSB-071LH: Service manual

Daewoo DSB-071LH Owner's Manual Manual pdf 7 page image

1. Determine the type of wall (sheetrock, concrete, etc.)and make sure it is strong enough to hold indoor unit.Select an approximate position for the unit, taking therequired distances away from walls/AC outlet intoconsideration.INSTALLATION6INDOOR UNIT• Do not install the unit in an area with direct sunlight, nearheat sources (radiator, etc.), or an area where leakageof flammable gas may be expected.• Select a position in the room, high on the wall, where thewhole room can be uniformly cooled.• Select a location that can hold the weight of the unit andwhere the copper tubing, drain hose and Indoor toOutdoor Wire have the shortest distance to the Outdoorunit.• Make sure the Indoor unit is installed at least 10cm(3.95in) away from the top and left side wall and at least30cm (11.8in) from AC outlet and right side wall (seeOverview figure on previous page).OUTDOOR UNIT• Do not install the unit in an area near heat sources, ex-haust fans, or an area where leakage of flammable gasmay be expected.• Do not install the unit in a humid, damp or uneven loca-tion.• Select a location that is well ventilated .• Leave enough room around the unit for air intake, ex-haust and possible maintenance.2. Determine if the hole is to be made at the left or righthole location.10 mm10 mm150 mm 60 mm3. Using drill with hole-cutting attachment or equivalent,cut a hole 65mm (2.56") in diameter. The hole shouldbe made at a slight downward slant to the outdoor side.Measure the thickness from the inside to outside edgesand cut a PVC pipe at a slight angle 1/4" shorter thanthe thickness of the wall and insert pipe in wall.4. For sheetrock, wooden or similar wall, measuredown from the ceiling using a level or tape measureand attach the wall bracket to the wall using 4screws. If you are not able to line up the holes withthe beams, use toggle bolts. Make sure the wallbracket is even and flush against the wall.Indoor OutdoorCut at slight angleCAUTION• Before making hole, make sure there are no studs, pipes,electrical wiring or conduit directly behind the area to becut.For Concrete, or similar type wall, make holes into the wall and insert concrete nails instead of screws.INSTALLING THE WALL BRACKET:To install the wall bracket, follow the procedures below. One hole is required for the tubing and may be either on the leftor right side.SELECTING A SITE: