Dahua DHI-ARC3008C Installer Manual

Also see for ARC3008C: User manual

Contents

Dahua DHI-ARC3008C Installer Manual Manual pdf 63 page image

Alarm Control Panel Installer Manual62MONITOR STATION1.36After entering the Installer Menu, press and to scroll up and down until you reach theStep 1MONITOR STATION menu for digital Contact ID alarm centralization parameters (up to 3 MonitorStation numbers). See Figure 1-34.Monitor stationFigure 1-34Press and to select the monitor station that you want to configure, and then pressStep 2.Configure the settings. See Table 1-30.Step 3Press and to alter the options. Press to confirm the setting and move to the nextsubmenu.Table 1-30 Monitor station settingsSubmenu SettingSTATE ACTIVE: The PSTN number is enabled.ISOLATE: The PSTN number is set but temporarily locked.MODE Set the digital protocol for each service center number (Only CONTACT IDfor now).TEST DATE Set the date when to test PSTN.TEST TIME Set the specific time when to test PSTN.Press to return to the monitor station selection menu.Step 4Then you can continue with programming other monitor stations (up to three), or press toreturn to the MONITOR STATION menu from where you can press and to move to thenext menu or press to exit from the Installer Menu.VOCAL MESSAGES1.37After entering the Installer Menu, press and to scroll up and down until you reach theStep 1VOCAL MESSAGES menu. See Figure 1-35.