Dalsa X64-AN Quad User Manual
                                                                                                                                 | |
Contents
| 
10 Installing the X64-AN Quad X64-AN Quad User's Manual If using Windows Vista or Windows 7, Windows will display its Found New Hardware dialog.Click on the default "Ask me again later" and continue with the installation. Note that if you selectthe third option "Don't show this message again for this device", there will be no prompt if theTeledyne DALSA board is installed in the same computer.Sapera LT Library Installation Insert the Teledyne DALSA Sapera Essential CD-ROM. With AUTORUN enabled, theinstallation menu automatically displays. With AUTORUN not enabled, use Windows Explorer and browse to the root directory of theCD-ROM. Execute launch.exe to start the installation menu and install the required Saperacomponents. Continue with the installation of the board driver as described in the next section. The installation program will prompt you to reboot the computer.Refer to Sapera LT User’s Manual for additional details about Sapera LT.X64-AN Quad Driver InstallationThe X64-AN Quad board driver supports installation in a Windows XP, Windows Vista, or Windows7 system. After installing Sapera, continue by selecting the X64-AN Quad driver installation. If Sapera was previously installed, insert the Teledyne DALSA Sapera Essential CD-ROM toinstall the board driver. With AUTORUN enabled, the installation menu automatically displays.Install the X64-AN Quad driver. With AUTORUN not enabled, use Windows Explorer and browse to the root directory of theCD-ROM. Execute launch.exe to start the installation menu and install the X64-AN Quad driver.During the late stages of the installation, the X64-AN Quad firmware loader application starts.See the description in the following section. If Windows displays any unexpected message concerning the installed board, power off thesystem and verify that the X64-AN Quad is installed properly in the computer slot.X64-AN Quad Firmware LoaderThe Device Manager-Firmware Loader program automatically executes at the end of the driverinstallation and on every subsequent reboot of the computer. It will determine if the X64-AN Quadrequires a firmware update. If firmware is required, a dialog displays. This dialog also allows the userto load firmware for alternate operational modes of the board.Important: In the vary rare case of firmware loader errors please see “Recovering from a FirmwareUpdate Error” on page 28. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine