Danfoss VLT AQUA FC 202 Operating Instructions Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

Display lines 2 and 3 in the LCP show the status for TimedActions Mode (0-23 Display Line 2 Large and 0-24 DisplayLine 3 Large, setting [1643] Timed Actions Status).NOTICEA change in mode via the digital inputs can only takeplace if 23-08 Timed Actions Mode is set for [0] TimesActions Auto.If commands are applied simultaneously to the digitalinputs for Constant OFF and Constant ON, the TimedActions mode will change to Timed Actions Auto and thetwo commands will be disregarded.If 0-70 Date and Time is not set or the frequencyconverter is set to HAND or OFF mode (e.g. via the LCP),the Timed Actions mode will be change to Timed ActionsDisabled.The Timed Actions have a higher priority than the sameactions/commands activated by the digital inputs or theSmart Logic Controller.The actions programmed in Timed Actions are mergedwith corresponding actions from digital inputs, controlword via bus and Smart Logic Controller, according tomerge rules set up in parameter group 8-5* Digital/Bus.NOTICEThe clock (parameter group 0-7*) must be correctlyprogrammed for Timed Actions to function correctly.NOTICEWhen mounting an Analog I/O MCB 109 option card, abattery back up of the date and time is included.NOTICEThe PC-based Configuration Tool MCT 10 Set-upSoftware comprises a special guide for easyprogramming of Timed Actions.23-00 ON TimeArray [10]Range: Function:Size related* [ 0 - 0 ] Sets the ON time for the Timed Action.NOTICEThe frequency converter has noback up of the clock function andthe set date/time will reset todefault (2000-01-01 00:00) after apower down unless a Real TimeClock module with back up isinstalled. In 0-79 Clock Fault it ispossible to program for a Warningin case clock has not been setproperly, e.g. after a power down.23-01 ON ActionArra [10]Option: Function:Select the action during ON Time.See 13-52 SL Controller Action fordescriptions of the options.[0] Disabled[1] No action[2] Select set-up 1[3] Select set-up 2[4] Select set-up 3[5] Select set-up 4[10] Select preset ref 0[11] Select preset ref 1[12] Select preset ref 2[13] Select preset ref 3[14] Select preset ref 4[15] Select preset ref 5[16] Select preset ref 6[17] Select preset ref 7[18] Select ramp 1[19] Select ramp 2[22] Run[23] Run reverse[24] Stop[26] DC Brake[27] Coast[28] Freeze output[29] Start timer 0[30] Start timer 1[31] Start timer 2[32] Set digital out A low[33] Set digital out B low[34] Set digital out C low[35] Set digital out D low[36] Set digital out E lowHow to programme the freque... VLT AQUA Drive FC 202 Operation InstructionsMG20P402 - Rev. 2013-12-16 1095 5