Danfoss VLT AQUA FC 202 Operating Instructions Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

Contents

Operation keysKeys for local control are found at the bottom of thecontrol panel.130BP046.10Handon Off Autoon ResetIllustration 4.17 Operation keys of the numerical LCP (NLCP)[Hand on]enables control of the frequency converter via the LCP.[Hand on] also starts the motor and it is now possible toenter the motor speed data by means of the navigationkeys. The key can be [1] Enabled or[0] Disabled via0-40 [Hand on] Key on LCP.External stop signals activated by means of control signalsor a serial bus will override a 'start' command via the LCP.The following control signals are still active when [Handon] is activated:• [Hand on] - [Off] - [Auto on]• Reset• Coasting stop inverse• Reversing• Set-up select lsb - Set-up select msb• Stop command from serial communication• Quick stop• DC brake[Off]stops the connected motor. The key can be [1] Enabled or[0] Disabled via 0-41 [Off] Key on LCP.If no external stop function is selected and the [Off] key isinactive the motor can be stopped by disconnecting themains supply.[Auto on]enables the frequency converter to be controlled via thecontrol terminals and/or serial communication. When astart signal is applied on the control terminals and/or thebus, the frequency converter starts. The key can be [1]Enabled or [0] Disabled via 0-42 [Auto on] Key on LCP.NOTICEAn active HAND-OFF-AUTO signal via the digital inputshas higher priority than the control keys [Hand on] [Autoon].[Reset]is used for resetting the frequency converter after an alarm(trip). The key can be [1] Enabled or[0] Disabled via0-43 [Reset] Key on LCP.4.1.3 Changing Data1. Press [Quick Menu] or [Main Menu] key.2. Press [▲] and [▼] to find parameter group to edit.3. Press [OK] key.4. Press [▲] and [▼] to find parameter to edit.5. Press [OK] key.6. Press [▲] and [▼] to select correct parametersetting. Or, to move to digits within a number,press keys. Cursor indicates digit selected tochange. [▲] increases the value, [▼] decreases thevalue.7. Press [Cancel] to disregard change, or press [OK]to accept change and enter new setting.4.1.4 Changing a Text ValueIf the selected parameter is a text value, change the textvalue with the [▲]/[▼] keys.[▲] increases the value, and [▼] decreases the value. Placethe cursor on the value to be saved and press [OK].130BP068.10740RPM0 -01 Language[0] English10.64 A 1 [1]0-0*Basic SettingsIllustration 4.18 Display Example4.1.5 Changing a Group of Numeric DataValuesIf the selected parameter represents a numeric data value,change the selected data value with the [◄] and [►] keysas well as the up/down [▲] [▼] keys. press [◄] and [►] tomove the cursor horizontally.130BP069.101- 6*113 RPM 1.78 A 1(1)Load depen. setting1 - 60 Low speed loadcompensation100%Illustration 4.19 Display ExampleHow to operate the frequenc... VLT AQUA Drive FC 202 Operation InstructionsMG20P402 - Rev. 2013-12-16 754 4