Danfoss vlt AQUA Instruction Manual

Also see for vlt aqua: Instructions Design guide Operating instructions Design guide Operating instructions

5.1.9 AC line input connections for B4, C1 and C2Figure 5.15: How to connect to line power and groundingfor B4.Figure 5.16: How to connect to line power and groundingfor C1 and C2.5.1.10 AC line input connections for C3 and C4Figure 5.17: How to connect C3 to line power and ground-ing.Figure 5.18: How to connect C4 to line power and ground-ing.5.1.11 How to connect the motor - forewordSee section General Specifications for correct dimensioning of motor cable cross-section and length.• Use a shielded/armored motor cable to comply with EMC emission specifications (or install the cable in a metal conduit).• Keep the motor cable as short as possible to reduce the noise level and leakage currents.• Connect the motor cable shield/armor to both the decoupling plate of the adjustable frequency drive and to the metal of the motor. (The sameapplies to both ends of the metal conduit if used instead of a shield.)VLT® AQUA DriveInstruction Manual 5 Electrical installationMG.20.M5.22 - VLT® is a registered Danfoss trademark 5-115