References320 Gryphon™ I GD4100/GM4100/GBT4100/L GD4300STAR Radio Protocol TimeoutThis parameter sets the valid wait time before transmission between the handheld reader andBase Station is considered failed.When setting this parameter, take into consideration the radio traffic (number of readers in thesame area). The selectable range for this feature is from 02 to 25 seconds.Follow these instructions to set this feature:1. Determine the desired setting.2. Pad the number with leading zeroes to yield two digits. For example: 2 = 02, 5 = 05, 25 =25, etc3. Go to page 272 and scanScan the ENTER/EXIT PROGRAMMING MODE barcode toenter Programming Mode.4. Scan the barcode: SELECT RADIO PROTOCOL TIMEOUT.5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that representthe duration which was determined in the steps above. You will hear a two-beep indica-tion after the last character.If you make a mistake before the last character, scan the CANCEL barcode toabort and not save the entry string. You can then start again at the begin-ning.6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit ProgrammingMode.This completes the procedure. See Table 46 for some examples of how to set this feature.Table 46. STAR Radio Protocol Timeout ExamplesSTEP ACTION EXAMPLES1 Desired Setting 2 Seconds 5 Seconds 10 Seconds 25 Seconds2 Pad with leading zero(es) 02 05 10 253 Scan ENTER/EXIT PROGRAMMING MODE4 Scan SELECT INTERCODE DELAY SETTING5 Scan Two Characters FromAppendix D, Keypad ‘0’ and ‘2’ ‘0’ and ‘5’ ‘1’ and ‘0’ ‘2’ AND ‘5’6 Scan ENTER/EXIT PROGRAMMING MODE
