References286 Gryphon™ I GD4100/GM4100/GBT4100/L GD4300• RTS/XON/XOFF — RTS is asserted during transmissions. CTS is ignored. XON andXOFF gate transmissions.• RTS On/CTS — RTS is always asserted. CTS gates transmissions.RTS/CTS Scan Control — RTS is asserted during transmissions. CTS gates transmissions andcontrols enable and disable state of scanner.RS-232/USB COM ParametersIntercharacter DelayThis parameter specifies the intercharacter delay between the end of one character and thebeginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in10ms increments. A setting of zero specifies no delay.To set the delay:1. Determine the desired setting in milliseconds.2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter ProgrammingMode.4. Go to page 47 and scan the barcode: SELECT INTERCHARACTER DELAY SET-TING.5. Scan the appropriate two digits from the keypad in Appendix D Keypad, that representthe duration which was determined in the steps above. You will hear a two-beep indica-tion after the last character.If you make a mistake before the last character, scan the CANCEL barcode toabort and not save the entry string. You can then start again at the beginning.6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.This completes the procedure. See Table 28 for some examples of how to set this feature.Table 28. Intercharacter Delay Setting ExamplesSTEP ACTION EXAMPLES1 Desired Setting 50ms 150ms 600ms 850ms2 Divide by 10 (pad with leadingzeroes to yield two-digits) 05 15 60 853 Scan ENTER/EXIT PROGRAMMING MODE4 Scan SELECT INTERCHARACTER DELAY SETTING5 Scan Two Characters FromAppendix D Keypad ‘0’ and ‘5’ ‘5’ and ‘0’ ‘6’ and ‘0’ ‘8’ and ‘5’6 Scan ENTER/EXIT PROGRAMMING MODE
