Technical Specifications326 Gryphon™ I GD4100/GM4100/GBT4100/L GD4300Table 51Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.Label Program-ming Mode EntryA valid programming label hasbeen scanned. LED blinks continuously Reader sounds four low frequencybeeps.Label Program-ming Mode Rejec-tion of LabelA label has been rejected.N/AReader sounds three times at low-est frequency & current volume.Label Program-ming Mode Accep-tance of PartialLabelIn cases where multiple labelsmust be scanned to program onefeature, this indication acknowl-edges each portion as it is success-fully scanned.N/AReader sounds one short beep athighest frequency & current vol-ume.Label Program-ming Mode Accep-tance ofProgrammingConfiguration option(s) have beensuccessfully programmed vialabels and the reader has exitedProgramming Mode.N/AReader sounds one high frequencybeep and 4 low frequency beepsfollowed by reset beeps.Label Program-ming Mode Can-cel Item EntryCancel label has been scanned.N/AReader sounds two times at lowfrequency and current volume.. Programming Mode IndicationsError CodesUpon startup, if the reader sounds a long tone, this means the reader has not passed itsautomatic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader isreset, the sequence will be repeated. The following table describes the LED flashes/beep codesassociated with an error found.NUMBER OF LEDFLASHES/BEEPS ERROR CORRECTIVE ACTION1 ConfigurationContact Helpdesk for assistance2 Interface PCB4 Reader Module5 Laser Pointer (if so equipped)6 Digital PCB14 CPLD/Code Mismatch
