References292 Gryphon™ I GD4100/GM4100/GBT4100/L GD4300Enable CharacterSpecifies the value of the RS-232 host command used to enable the reader.ASCII characters or any hex value from 0 to 0xFF can be selected.Setting to previously defined characters such as XON, XOFF, or hostcommands conflicts with normal operation of these characters. 8-bit data is not recognized when the option Data Bits has been setas 7 Data Bits.To set this feature:Determine the desired character or value. A setting of 0xFF indicates the Enable Character isnot used (not available).1. Determine the desired character or value.2. Use the ASCII Chart on the inside back cover of this manual to find the hex equivalentfor the desired character/value.3. Go to page 53 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enterProgramming Mode.4. Scan the barcode: SELECT ENABLE CHARACTER SETTING.5. Scan the appropriate two alpha-numeric characters from the keypad in Appendix D Key-pad, that represent the desired character/value in step 2 above. The second character willcause a two-beep indication.6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit ProgrammingMode.This completes the procedure. See Table 34 for some examples of how to set this feature.Table 34. Enable Character Setting ExamplesSTEP ACTION EXAMPLES1 Desired character/value ‘e’ ‘}’ ‘E’ Enable CommandNot Used2 Hex equivalent from ASCIIChart 0x65 0x7D 0x45 0xFF3 Scan ENTER/EXIT PROGRAMMING MODE4 Scan SELECT DISABLE CHARACTER VALUE SETTING5 Scan Two Characters FromAppendix D Keypad ‘6’ and ‘5’ ‘7’ and ‘D’ ‘4’ and ‘5’ ‘F’ AND ‘F’6 Scan ENTER/EXIT PROGRAMMING MODE
