Technical SpecificationsProduct Reference Guide 325LED and Beeper IndicationsThe reader’s beeper sounds and its LED illuminates to indicate various functions or errors onthe reader. An optional “Green Spot” also performs useful functions. The tables below list theseindications. One exception to the behaviors listed in the tables is that the reader’s functions areprogrammable, and may or may not be turned on. For example, certain indications such as thepower-up beep can be disabled using programming barcode labels.Table 50.INDICATION DESCRIPTION LED BEEPERPower-up Beep The reader is in the process of pow-ering-up.Reader beeps four times at highestfrequency and volume uponpower-up.Good Read Beep A label has been successfullyscanned by the reader.LED behavior for this indica-tion is configurable via thefeature “Good Read: Whento Indicate”The reader will beep once at cur-rent frequency, volume, mono/bi-tonal setting and duration upon asuccessful label scan.ROM Failure There is an error in the reader'ssoftware/programming Flashes Reader sounds one error beep athighest volume.Limited ScanningLabel ReadIndicates that a host connection isnot established when the IBM orUSB interface is enabled.N/AReader 'chirps' six times at thehighest frequency and current vol-ume.Reader ActiveModeThe reader is active and ready toscan. The LED is lit steadilyaa. Except when in sleep mode or when a Good Read LED Duration other than 00 is selectedN/AReaderDisabledThe reader has been disabled bythe host.The LED blinks continuously N/AGreen Spot is oncontinuouslyWhile in Stand Mode or TriggerStand Mode the green spot shallbe on while in stand watch state.N/A N/AGreen Spotaflashes momen-tarilyUpon successful read of a label, thesoftware shall turn the green spoton for the time specified by theconfigured value.N/A N/ALED and Beeper Indications
