References312 Gryphon™ I GD4100/GM4100/GBT4100/L GD4300Display SettingsDisplay ModeThe user can control the reader display behavior according to the following selections:Local Echo mode: When a barcode is read with the reader:• The code is sent to the Host.• The reader display is cleared.• The code is also sent to the reader display (Local Echo).• The cursor is positioned after the last printed character on the reader display.Normal mode: When a barcode is read with the reader:• The code is sent to the Host.• The reader display is not cleared. Therefore if any previous data was displayed on thereader screen it remains.• There is no Local Echo to the reader display.Clear Display After Decode mode: When a barcode is read with the reader:• The code is sent to the Host.• The reader display is cleared. Therefore if any previous data was displayed on the readerscreen it is cancelled and the screen remains blank.• There is no Local Echo of the code to the reader display.Host messages sent to the reader are always written to the reader display.RF FeaturesConfiguration UpdateAutomatic Configuration UpdateWhen this feature is enabled, the base station and reader will keep their configurationssynchronized. If a reader's configuration is altered by reading programming labels, this change isautomatically transferred and updated in a linked base station. Likewise, if the base station'sconfiguration is changed using Aladdin or by host commands, then the reader's configurationwill automatically be updated if this feature is enabled.RF Address StampingSource Radio Address Delimiter CharacterThis option specifies the delimiter character to be placed between the label data and radioaddress when address stamping is enabled.This feature only applies if "Source Radio Address Transmission"onpage 269 is enabled.
