References308 Gryphon™ I GD4100/GM4100/GBT4100/L GD4300Scanning FeaturesScan ModeThis mode is associated with typical handheld reader operation. Selects the scan operating modefor the reader. The following selections are valid for all models:Trigger Single. When the trigger is pulled, scanning is activated until one of the followingoccurs:- Scanning Active Time has elapsed- a label has been read- the trigger is releasedTrigger Hold Multiple. When the trigger is pulled, scanning starts and the product scans untilthe trigger is released or Scanning Active Time has elapsed. Reading a label does not disablescanning. Double Read Timeout prevents undesired multiple reads of the same label while inthis mode.Trigger Pulse Multiple. When the trigger is pulled, continuous scanning is activated untilScanning Active Time has elapsed or the trigger has been released and pulled again. DoubleRead Timeout prevents undesired multiple reads of the same label while in this mode.Flashing. The reader flashes1 on and off regardless of the trigger status. Flash rate is controlledby Flash On Time and Flash Off Time. When Flash is ON the imager reads continuously; whenFlash is OFF scanning is deactivated.Flashing is the recommended scan mode for Gryphon L hands-free(stand mode) of operationAlways On. No trigger pull is required to read a barcode. Scanning is continually on. If thetrigger is pulled, the reader acts as if it is in Trigger Single Mode. Double Read Timeoutprevents undesired multiple reads of the same label while in this mode.The following two features are valid only for the Gryphon I (desk and mobile), but not theGryphon Laser model. See "Laser Features"on page 281 for specific parameters for the Lasermodel.Stand Mode. No trigger pull is required to read a barcode. Scanning is turned on automaticallywhen an item is placed in the reader’s field of view. If the trigger is pulled, the reader acts as if itin single read mode. Double Read Timeout prevents undesired multiple reads while in thismode.Trigger Object Sense. This mode is similar to Stand Mode, except that a trigger pull is requiredto activate the decoder.1. Controlled by Flash On Time.
