References264 PowerScan™ PD9330/PBT9300/PM9300Intercharacter DelayThis parameter specifies the intercharacter delay between the end of onecharacter and the beginning of the next. The delay can be set within a rangeof zero (0) to 990 milliseconds in 10ms increments. A setting of zero speci-fies no delay.This feature applies ONLY to the Keyboard Wedge interface.To set the delay:1. Determine the desired setting in milliseconds.2. Divide the desired setting by 10 (setting is in 10ms increments). Padthe result with leading zeroes to yield two digits. For example: 0 = 00,5 = 05, 20 = 20, etc.3. Go to page 30 and scan the ENTER/EXIT PROGRAMMING MODE bar codeto enter Programming Mode.4. Scan the bar code: SELECT INTERCHARACTER DELAY SETTING.5. Scan the appropriate two digits from the keypad in Appendix D, Key-pad, that represent the duration which was determined in the stepsabove. You will hear a two-beep indication after the last character.If you make a mistake before the last character, scan the CANCEL barcode to abort and not save the entry string. You can then start againat the beginning.6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Program-ming Mode.This completes the procedure. See Table 39 for some examples of how toset this feature.Table 39. Intercharacter Delay Setting ExamplesSTEP ACTION EXAMPLES1 Desired Setting 50ms 150ms 600ms 850ms2Divide by 10 (and pad withleading zeroes to yieldtwo-digits)05 15 60 853 Scan ENTER/EXIT PROGRAMMING MODE4 Scan SELECT INTERCHARACTER DELAY SETTING5 Scan Two Characters FromAppendix D, Keypad ‘0’ and ‘5’ ‘1’ and ‘5’ ‘6’ and ‘0’ ‘8’ and ‘5’6 Scan ENTER/EXIT PROGRAMMING MODE
