Enter/Exit Programming ModeProduct Reference Guide 33ACK NAK Timeout ValueThis option specifies the amount of time the reader waits for an ACK char-acter from the host following label transmission. The selectable timeoutrange is 200 milliseconds to 15,000ms (15 seconds) in 200ms increments.A selection of 0 disables the timeout.See page 259 for more information on setting this feature.$CR2ATSelect ACK NAK Timeout Value SettingTo configure this feature, scan the ENTER/EXITPROGRAMMING MODE bar code above, then the barcode at left followed by the digits from the Alphanu-meric characters in Appendix D, Keypad repre-senting your desired character(s). End by scanningthe ENTER/EXIT bar code twice.Make a mistake? Scan the CANCEL bar code to abortand not save the entry string. You can then startagain at the beginning.~CANCELDEFAULT 01 ACK NAK Timeout value is 200msACK NAK Retry CountThis feature specifies the number of times the reader retries a label trans-mission due to a retry condition. The selectable range is from 1 to 254retries. A selection of 0 disables the count, and a selection of 255 specifiesunlimited retries. See page 260 for more information.$CR2ARSelect ACK NAK Retry Count SettingTo configure this feature, scan the ENTER/EXITPROGRAMMING MODE bar code above, then the barcode at left followed by the digits from the Alphanu-meric characters in Appendix D, Keypad repre-senting your desired character(s). End by scanningthe ENTER/EXIT bar code twice.Make a mistake? Scan the CANCEL bar code to abortand not save the entry string. You can then startagain at the beginning.~CANCELDEFAULT 003 = 3 Retries
