System SettingsYou can change most system settings from your software program or operator panel. If your multifunctionprinter is attached to the network, you can change settings from the Dell Printer Configuration Web Tool.To launch the Dell Printer Configuration Web Tool, type the printer IP address in your Web browser. Printa printer settings page to find your printer's IP address (see "Printing a System Settings Page").Settings from the software program update the default system settings for the multifunction printer. Settingsfrom the printer driver only apply to the job you are sending to the multifunction printer.If you cannot change a setting from your software program, use the printer operator panel or the DellPrinter Configuration Web Tool. Changing a system setting from the printer operator panel or from theDell Printer Configuration Web Tool makes that setting the user default.Printing a System Settings PageThe system settings page lists all the options you purchased or installed. If a feature or an option is notlisted, you need to check your installation.Press until >SETUP appears, and then press .1.Press until >Reports appears, and then press .2.System Settings is displayed. Press .3.The system settings page is printed.Verify that the options you installed are correctly listed under Printer Options.4.If an option you installed is not listed, turn off the multifunction printer, unplug the power cord, andreinstall the option.5.Verify the amount of memory installed is correctly listed under General.6.Using the Operator Panel to Change System SettingsYou can select menu items and corresponding values from the operator panel.When you first enter the printer menus from the operator panel, you see an asterisk (*) next to a value inthe menus.Factory defaults may vary for different countries.
