Select Trans. Always to always forward the incoming faxes.Select Not Trans. not to forward incoming faxes. You can set the fax number to whichfaxes are forwarded. Then, you can enter the start time and/or the end time. The Print LocalCopy option allows you to set the multifunction printer to print the fax, if fax forwarding iscompleted with no error.Fwd.SettingsNumYou can set the number of the multifunction printer to always forward all of the incomingfaxes to the specified destination.Fwd. SetPrintPrints all of the ongoing faxes when you can set the multifunction printer to always forwardthe faxes to the specified destination.Prefix Dial You can select whether or not to add the prefix number when you send a fax.Prefix DialNumYou can set a prefix dial number up to five digits. This number dials before any auto dialnumber is started. It is useful for accessing the PABX exchange.DiscardSizeWhen receiving a document as long as or longer than the paper installed in yourmultifunction printer, you can set the multifunction printer to discard any excess at thebottom of the page. If the received page is outside the margin you set, it will print on twosheets of paper at the actual size. When the document is within the margin and the AutoReduction feature is turned on, the multifunction printer reduces the document to fit it ontothe appropriate sized paper and discard does not occur. If the Auto Reduction feature isturned off or fails, the data within the margin will be discarded.Color Fax Set whether the multifunction printer sends and receives color faxes.Extel HookThreshYou can set the threshold value for the OnHook mode.Country You can select the country where the multifunction printer is used.Fwd. ErrorPrintPrints the document failed to transfer when Forward Set Print is set to Off .NOTE: Prefix Dial only supports the environment where you send a fax to send a fax to the externalline number. To use Prefix Dial, you must do the following from the operator panel.Use and to select SETUP Admin Menu Fax Settings Line Type . Select PBX , and thenpress .1.Use and to select SETUP Admin Menu Fax Settings Prefix Dial . Select On , and thenpress .2.Use and to select SETUP Admin Menu Fax Settings Prefix Dial Num . Enter amaximum of five-digit prefix number from 0-9, *, and #.3.Advanced Fax SettingsNOTE: The advanced fax settings are only meant for advanced users. Incorrect settings on the Dell3115cn may damage the device.
