2.Press to select On , and then press .3.Press Cancel to return to the standby mode.4.Sending a Delayed FaxThe Delayed Start mode can be used to save scanned documents for transmission at a specified time inorder to take advantage of lower long distance rates.Load the document(s) face up with top edge in first into the ADF.ORPlace a single document face down on the document feeder glass.For details about loading a document, see "Loading an Original Document ".1.Press until >FAX appears, and then press .2.Adjust the document resolution to suit your fax needs (see "Adjusting the Document Resolution ").If you need to change the contrast, see "Lighter/Darker ".3.Press until >Delayed Start appears.4.Press to select On , and then press .5.Enter the start time using the number keypad.6.Enter the number of the remote machine using the number keypad, and then press .To enter the number, you can use speed dial or group dial numbers. For details, see "Automatic Dialing".Press Start to scan data.7.Once Delayed Start mode is activated, your multifunction printer stores all of the documents to be faxed intoits memory and sends them at the programmed time. After faxing in the Delayed Start mode is complete,the data in the memory is cleared.Specifying the Fax SettingsChanging the Fax Settings OptionsPress until >SETUP appears, and then press .1.Press until >Admin Menu appears, and then press .2.Press until >Fax Settings appears, and then press .3.Press until the desired menu item appears, and then press .4.5.
