Dell 8 Owner's Manual

Also see for PowerEdge M1000e: Manual Command reference guide Update Getting started guide Installation guide

Contents

Dell 8 Owner's Manual Manual pdf 112 page image

112 About Your SystemAlert! Unsupportedmemory, incompletesets, or unmatchedsets. Thefollowing memoryDIMMs have beendisabled:l,m,nThe installed memoryconfiguration is invalid.Add, move, or removememory modules to achievea configuration supported bythe system. See "SystemMemory" on page 159.Caution! NVRAM_CLRjumper isinstalled onsystem board.NVRAM_CLR jumper isset to "on."Set the NVRAM_CLRjumper to "off." See "BladeSystem Board JumperSettings" on page 309 for thejumper location.CPUs withdifferent cachesizes detected.Mismatched processors areinstalled.Install a correct version ofthe processor so that bothprocessors have the samecache size. See "Processors"on page 225.Decreasingavailable memory.Faulty or improperlyinstalled memorymodules.Ensure that all memorymodules are properlyinstalled. See"Troubleshooting BladeMemory" on page 297.DIMMs disabled - SMIchannel trainingfailure.The memory modules arenot properly seated.The memory moduleconnectors or theprocessor socket may beexposed to dust.The processor has bentpins.Reseat or replace MemoryModules. See "SystemMemory" on page 159.Ensure that the memorymodule connectors andprocessor sockets are clean.Verify that there are no bentpins on the processor. If theprocessor has bent pins, see"Getting Help" on page 337.DIMMs disabled - MemoryBuffercommunicationerror.Table 1-26. Blade Messages(continued)Message Causes Corrective Actions