312 System Board InformationPowerEdge M710 Jumper SettingsFigure 7-4 shows the location of the configuration jumpers on the bladesystem board. Table 7-4 lists the jumper settings.NOTE: Figure 7-4 is oriented with the front end of the blade system board facing tothe right.Table 7-4. PowerEdge M710 Jumper SettingsPWRD_EN (default) The password feature is enabled. (Pins 2-3)The password feature is disabled. (Pins 1-2)NVRAM_CLR (default) The configuration settings are retained atsystem boot. (Pins 4-5)The configuration settings are cleared at thenext system boot. (Pins 5-6)(If the configuration settings become corruptedto the point where the system does not boot,install the jumper and boot the system. Removethe jumper before restoring the configurationinformation.)
