Federal Communications Commission (FCC) complianceinformation statementThis product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 ofthe FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation.The FCC Class B limits are designed to provide reasonable protection against harmful interference when theequipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, which can be determined by turningthe equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult your point of purchase or service representative for additional suggestions.The manufacturer is not responsible for radio or television interference caused by using other than recommendedcables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications couldvoid the user's authority to operate this equipment.Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device,use a properly shielded and grounded cable such as Lexmark part number 1021294 for USB attach. Use of a substitutecable not properly shielded and grounded may result in a violation of FCC regulations.Any questions regarding this compliance information statement should be directed to:Director of Lexmark Technology & ServicesLexmark International, Inc.740 West New Circle RoadLexington, KY 40550(859) 232–3000Noise emission levelsThe following measurements were made in accordance with ISO 7779 and reported in conformance with ISO 9296.Note: Some modes may not apply to your product.1-meter average sound pressure, dBAPrinting 40 dBAScanning 50 dBACopying 40 dBAReady inaudibleNotices120
