Scan was not successfulIf the "Before you troubleshoot" checklist does not solve the problem, then try one or more of the following:C HECK THE USB CONNECTION1 Check the USB cable for any obvious damage. If the cable is damaged, then use a new one.2 Firmly plug the square end of the USB cable into the back of the printer.3 Firmly plug the rectangular end of the USB cable into the USB port of the computer.The USB port is marked with a USB symbol.Note: If you continue to have problems, then try another USB port on the computer. You may have connected toa defective port.RESTART THE COMPUTERScanning takes too long or freezes the computerIf the "Before you troubleshoot" checklist does not solve the problem, then try one or more of the following:C LOSE OTHER SOFTWARE PROGRAMS THAT ARE NOT BEING USEDU SE A LOWER SCANNING RESOLUTIONCannot scan to a computer over a networkIf the "Before you troubleshoot" checklist does not solve the problem, then try one or more of the following:MAKE SURE THE PRINTER AND THE DESTINATION COMPUTER ARE CONNECTED TO THE SAMENETWORKMAKE SURE THE PRINTER SOFTWARE IS INSTALLED ON THE DESTINATION COMPUTERFax troubleshooting• “Fax troubleshooting checklist” on page 121• “Cannot send faxes” on page 121• “Cannot receive faxes” on page 123• “Cannot run the fax software” on page 124• “Fax error messages on the printer control panel” on page 125For detailed descriptions of common terms and tasks, see the following:• “Setting up the printer to fax” on page 58• “Faxing FAQ” on page 74Troubleshooting120
