Wireless network setupConnecting in PBC modePress and hold the (WPS) button on the control panel for about 2 - 41 seconds until the status LED blinks quickly.The machine starts connecting to the wireless network. The LED blinksslowly for up to two minutes until you press the PBC button on theaccess point (or wireless router).Press the WPS (PBC) button on the access point (or wireless router).2 a The light blinks fast on the WPS LED. The machine is connecting tothe access point (or wireless router).b When the machine is successfully connected to the wirelessnetwork, the WPS LED light stays on.Connecting in PIN modeThe network configuration report, including PIN, must be printed (see1 "Printing a network configuration report" on page 135).In ready mode, press the (WPS) button for more than ten seconds onthe control panel.You can find your machine’s PIN.Press and hold the (WPS) button on the control panel for more than2 4 seconds until the status LED stays on.The machine starts connecting to the access point (or wireless router).You need to enter the eight-digit PIN within two minutes on the3 computer that is connected to the access point (or wireless router).The LED blinks slowly for up to two minutes until you enter the eight-digit PIN.The WPS LED blinks in the order below:a The light blinks fast on the WPS LED. The machine is connecting tothe access point (or wireless router).b When the machine is successfully connected to the wirelessnetwork, the WPS LED light stays on.Re-connecting to a networkWhen the wireless function is off, the machine automatically tries to re-connectto the access point (or wireless router) with the previously used wirelessconnection settings and address.In the following cases, the machine automatically re-connects to thewireless network:• The machine is turned off and on again.• The access point (or wireless router) is turned off and on again.2. Using a Network-Connected Machine 155
