104 Brocade Adapters Installation and Reference Manual53-1002144-01Confirming driver package installation3Confirming driver installation with HCMFollowing is the HCM procedure to display adapter information.1. Launch HCM.2. Select the adapter in the device tree.3. Select the Properties tab in the right pane to display the Properties dialog box.The dialog box displays adapter properties.Confirming driver installation with Windows toolsYou can use two methods to determine driver installation, depending on your Windows installation:the Driver Verifier and Device Manager.Driver Verifier ManagerVerify that the adapter storage driver (bfa) is loaded for HBAs, CNAs, Fabric Adapters and that thestorage driver and network driver (bna) are loaded for CNAs and Fabric Adapters with portsconfigured in CNA or NIC mode using the Driver Verifier Manager tool (Verifier.exe). The verifier.execommand is located in the Windows\System32 folder in Windows Server 2003 systems.Select the option to display the following information about currently installed drivers:• Loaded: The driver is currently loaded and verified.• Unloaded: The driver is not currently loaded, but it was loaded at least once since you restartedthe system.• Never Loaded: The driver was never loaded. This status can indicate that the driver's image fileis corrupted or that you specified a driver name that is missing from the system.Device ManagerVerify if the driver is installed and Windows is recognizing the adapter using the following steps.1. Open the Device Manager.• For CNAs, HBAs, and Fabric Adapters, when you expand the list of SCSI and RAIDcontrollers or Storage controllers an instance of the adapter model should display foradapter port installed.• For CNAs and Fabric Adapter ports configured in CNA or NIC mode, when you expandNetwork adapters, an instance of Brocade 10G Ethernet Adapter should also display foreach port installed.For example, if two two-port CNAs (total of four ports) are installed, four instances of theadapter model display (two under SCSI and RAID controllers and two under Network adapters).As another example, if only one port on a Fabric Adapter is configured in CNA or NIC mode, twoinstances of the adapter model display (one under SCSI and RAID controllers and one underNetwork adapters).2. Right-click an instance of your adapter displayed under Device Manager.3. Select Properties to display the Properties dialog box.
