106 Brocade Adapters Installation and Reference Manual53-1002144-01Confirming driver package installation3Confirming driver installation with Solaris toolsVerify if the driver packages installed successfully using the following commands:NOTEBrocade 804 and 1007 adapters are not supported on Solaris systems, so commands in this sectiondo not apply to these adapters.• These commands display information about loaded kernel modules.modinfo|grep bfamodinfo|grep bnaIf the storage driver package is installed, bfa Brocade Fibre Channel Adapter Driver shoulddisplay.If the network driver package is installed, bna Brocade Fibre Channel Adapter Driver shoulddisplay.• These commands check for and lists the installed driver package files.pkgchk -nv bfapkgchk -nv bna• This command displays all available information about software packages or sets that areinstalled on the system.pkginfo -lFor example, if the storage driver package is installed, bfa_pkg should display with a“complete” install status in the list of installed packages.PKGINST: bfaNAME: Brocade Fibre Channel Adapter DriverCATEGORY: systemARCH: sparc&i386VERSION: alpha_bld31_20080502_1205BASEDIR: /VENDOR: BrocadeDESC: 32 bit & 64 bit Device driver for Brocade Fibre Channel adaptersPSTAMP: 20080115150824INSTDATE: May 02 2008 18:22HOTLINE: Please contact your local service providerSTATUS: completely installedVMwareVerify if the adapter driver installed successfully using the following commands:esxcli software vib list | grep bfa
