Understanding the Tool Box Menus 159Fax SettingsPurpose:To configure the basic fax settings.Values:Receive Mode Telephone Automatic fax reception is turned off. You can receive a fax by picking up thehandset of the external telephone, and then pressing the remote receive code.Fax Automatically receives faxes.Telephone/Fax When the printer receives an incoming fax, the external telephone rings for thetime specified in Auto Rec Fax/Tel, and then the printer automatically receives afax. If an incoming call is not a fax, the printer beeps from the internal speakerindicating that the call is a telephone call.Ans Machine/Fax The printer can share a telephone line with an answering machine. In this mode,the printer will monitor the fax signal and pick up the line if there are fax tones. Ifthe phone communication is using serial transmission in your country (such asGermany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland), thismode is not supported.DRPD Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctivering service must be installed on your telephone line by the telephone company.After the telephone company has provided a separate number for faxing with adistinctive ring pattern, configure the fax setup to monitor for that specific ringpattern.Auto Rec Fax Available Range:0–255 secondsSets the interval at which the printer goes into the fax receive mode after receivingan incoming call.Auto Rec Fax/Tel Available Range:0–255 secondsSets the interval at which the printer goes into the fax receive mode after theexternal telephone receives an incoming call.Auto Rec Ans/Fax Available Range:0–255 secondsSets the interval at which the printer goes into the fax receive mode after theexternal answering machine receives an incoming call.Line Monitor Off Turns off the volume of the line monitor.Low Specifies the volume of the line monitor, which audibly monitors a transmissionthrough the internal speaker until a connection is made.MediumHighRing Tone Volume Off Turns off the volume of the ring tone.Low Specifies the volume of the ring tone, which indicates that an incoming call is atelephone call through the internal speaker when Receive Mode is set toTelephone/Fax.MediumHighLine Type PSTN Sets the line type to PSTN.PBX Sets the line type to PBX.Tone/Pulse Tone Sets the dialing type to Tone.Pulse (10PPS) Sets the dialing type to Pulse (10 pulse per second).Pulse (20PPS)*1 Sets the dialing type to Pulse (20 pulse per second).Resend Delay Available Range:3–255 secondsSpecifies the interval between transmission attempts.Redial Attempts Available Range:0–9Specifies the number of redial attempts to make when the destination fax numberis busy. If you enter 0, the printer will not redial.
