242 Copying6 If necessary, customize the copy settings including the number of copies, contrast, and image quality. See "SettingCopy Options" on page 235.7 Ensure that Start Copy is highlighted, and then press the (Start) button to begin copying.When you are using the document glass and Multiple-Up is set to Auto, or Manual, the display prompts youfor another page. Press the button to select Yes or No, and then press the (Set) button.If you select Yes, press the button to select Continue or Cancel, and then press the (Set) button.Margin Top/BottomTo specify the top and bottom margins of the copy:1 Load the document(s) face up with top edge in first into the ADF.ORPlace a single document face down on the document glass, and close the document cover.For details about loading a document, see "Making Copies From the ADF" on page 235 or "Making Copies Fromthe Document Glass" on page 233.2 Press the (Copy) button.3 Press the button until Preferences is highlighted, and then press the (Set) button.4 Press the button until Margin Top/Bottom is highlighted, and then press the (Set) button.5 Press the or button or enter the desired value using the numeric keypad, and then press the (Set)button.NOTE: Values marked by an asterisk (*) are the factory default menu settings.Margin Left/RightTo specify the left and right margins of the copy:1 Load the document(s) face up with top edge in first into the ADF.ORPlace a single document face down on the document glass, and close the document cover.For details about loading a document, see "Making Copies From the ADF" on page 235 or "Making Copies Fromthe Document Glass" on page 233.2 Press the (Copy) button.3 Press the button until Preferences is highlighted, and then press the (Set) button.4 Press the button until Margin Left/Right is highlighted, and then press the (Set) button.5 Press the or button or enter the desired value using the numeric keypad, and then press the (Set)button.NOTE: Values marked by an asterisk (*) are the factory default menu settings.4 mm*/0.2 inch* Specify the value in increments of 1 mm/0.1 inch.Available Range:0-50 mm/0.0-2.0 inch
