To add a login group in an ADS domain, complete the following:1. Select System Configuration → Active Directory.The Active Directory page is displayed. Under Settings, “Active Directory is configured” should be displayed; if not,you must configure your ADS domain before proceeding.2. Click Add Login Group on the options bar.The Active Directory Configuration dialog is displayed.3. In Login Group, type the name of the login group including the domain name; for example, Domain\Domain Admins.If your login group name contains spaces, you must not enclose it in quotation marks. (This differs from theequivalent CLI command.)4. Click Add Login Group to add the login group (or click Cancel to display the Active Directory page).If the addition is successful, a confirmation message displays.Changes made to the login group take effect on the next log in attempt (no active checking is done on the group, whichmatches how Windows ADS works).About the Global View PageThe Global View page displays a dashboard of operating statistics for all of the DR Series systems that you have addedto the view. From this page, you can monitor the status of your enterprise as well as easily navigate to any DR Seriessystem in your enterprise.Figure 9. Global View Page (DR4100 System)Global View SummaryNOTE: If an alert is displayed with a message that "Member units will fail to connect because non-Active Directorycredentials were used", see Prerequisites.The following table describes the statistics available in the Global View Summary:NOTE: The statistical values refresh every 15 seconds.115