4. In Password, enter the domain password for the DR Series system. This should be identical to the credentials usedin all other systems in the Global View.5. Click Reconnect.The DR Series system attempts to reconnect only those DR Series systems that are currently disconnected.The Reconnect DR Units Report is displayed, indicating whether the reconnection was successful or unsuccessful. If thereconnect action is successful, the Status of the connected DR Series system displays a green icon. However, if thereare unresolved underlying issues such as issues with the network connection, issues with a WAN connection, or issueswith the DR Series system that prevent a good connection, then the Reconnect DR Units Report indicates failure.Using the Reconnect ReportThe Reconnect DR Units Report provides information about your most recent attempt to reconnect DR Series systems.The link to access the Reconnect DR Units Report is only enabled after you attempt to reconnect DR Series systems. Toview the Reconnect DR Units Report, complete the following:1. On the Global View page, click Reconnect Report.The Reconnect DR Units Report is displayed. If all DR Series systems were successfully reconnected the last timeyou clicked Reconnect Units, then the report indicates that all DR Series systems were successfully connected.However, if the reconnect failed, then the Reconnect DR Units Report displays the FQDNs of the disconnected DRSeries systems with a message indicating the issue. For example, the message No route to host indicates that thesystem was unable to ping the DR Series system from the current location because either the system is down, orthe router is unable to route traffic to the system.2. After you review the Reconnect DR Units Report, click Close to return to the Global View page.120
