Dell Dimension 4500S Owner's Manual

Also see for Dimension 4500S: Manual 

Contents

72 Adding Partsw w w . d e l l . c o m | s u p p o r t . d e l l . c o m 3 Insert the module straight down into the connector, ensuring that itfits into the vertical guides at each end of the connector. Press firmlyon the ends of the module until it snaps into place.If you insert the module correctly, the securing clips snap into thecutouts at each end of the module.4 Close the computer cover (see page 72).5 Attach the computer stand (optional) (see page 16).NOTICE: To connect a network cable, first plug the cable into the networkwall jack and then plug it into the computer.6 Connect your computer and devices to electrical outlets, and turnthem on.7 Right-click the My Computer icon and then click Properties.8 Click the General tab.9 To verify that the memory is installed correctly, check the amount ofmemory (RAM) listed.1 Ensure that all cables are connected, and fold cables out of the way.Make sure cables are not routed over the drive cage—they will preventthe cover from closing properly.2 Ensure that no tools or extra parts are left inside the computer.3 Pivot the cover down and ensure that the release buttons click intoplace.4 Attach the computer stand (optional) (see page 16).NOTICE: To connect a network cable, first plug the cable into the networkwall jack and then plug it into the computer.5 Connect your computer and devices to electrical outlets, and turnthem on.