Documentation1 memory module 2 securing clip (2)7. Replace the computer cover (see Replacing the Computer Cover).NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.8. Connect your computer and devices to electrical outlets, and then turn them on.9. Right-click the My Computer icon, then click Properties.10. Click the General tab.11. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.Removing MemoryCAUTION: Before you perform any of the procedures in this section, follow the safety instructions in theProduct Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your bodybefore you touch any of your computer's electronic components. You can do so by touching an unpainted metal surfaceon the computer.1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Press outward the securing clip at each end of the memory module connector.4. Grasp the module and pull up.If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (10 of 68) [12/9/2007 11:22:24 PM]