Dell Dimension 9200 Service Manual

Also see for 9200: Owner's manual Owner's manual Setup guide Owner's manual Getting started guide

Contents

DocumentationPower SupplyCAUTION: Before you begin any of the procedures in this section, follow the safety instructions in theProduct Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your bodybefore you touch any of your computer's electronic components. You can do so by touching an unpainted metal surfaceon the computer.Removing the Power Supply1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Disconnect the DC power cables from the system board and the drives.NOTE: Note the routing of the DC power cables underneath the tabs in the computer frame as you remove them fromthe system board and drives. You must route these cables properly when you replace them to prevent them frombeing pinched or crimped.4. Remove any cables from the cable routing clip on the power supply.5. Remove the four screws that attach the power supply to the back of the computer frame.6. Press the release button located on the floor of the computer frame.7. Slide the power supply approximately 1 inch towards the front of the computer.8. Lift the power supply out of the computer.http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (47 of 68) [12/9/2007 11:22:24 PM]