Documentation4. Slide the floppy drive into the floppy drive bay until the sliding plate clicks into place and the drive snaps into position.5. Attach the power cable to the floppy drive. Attach the floppy-drive cable to the floppy drive and to the system board.6. Check all cable connections. Fold the ribbon cable and place it across the top of the processor shroud inserting the sidesunder the clips. Ensure that the cable does not block airflow for the fan and cooling vents.7. Replace the computer cover.NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to thecomputer.8. Connect your computer and devices to their electrical outlets, and then turn them on.See the documentation that came with the floppy drive for instructions on installing any software required for theoperation of the drive.9. Enter system setup (see Entering System Setup) and select the appropriate Diskette Drive option.10. Verify that your computer works correctly by running the Dell Diagnostics (see Dell Diagnostics).Media Card ReaderRemoving a Media Card ReaderCAUTION: Before you perform any of the procedures in this section, follow the safety instructions in theProduct Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your bodybefore you touch any of your computer's electronic components. You can do so by touching an unpainted metal surfaceon the computer chassis.1. Follow the procedures in Before You Begin.2. Lay the computer on its side so that the system board is on the bottom of the inside of the computer.3. Remove the computer cover (see Removing the Computer Cover).4. Remove the drive panel (see Removing the Drive Panel).5. Remove the drive panel insert (see Removing the Drive-Panel Insert).http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (37 of 68) [12/9/2007 11:22:24 PM]