Dell E30S002 Manual

3 Remove the expansion card holder.Steps1 Unpack the expansion card and prepare it for installation.For instructions, see the documentation accompanying the card.2 Open the expansion card latch adjacent to the slot you want to install the expansion card.3 Remove the existing expansion card or filler bracket from the expansion card holder.NOTE: Store this bracket for future use. Filler brackets must be installed in empty expansion-card slots to maintain FCCcertification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflowinside the system.4 Holding the card by its edges, position the card so that the card aligns with the expansion card connector.5 Insert the card firmly into the expansion card connector until the card is fully seated.6 Close the expansion card latch by pushing the latch up until the latch snaps into place.7 Connect the data cables to the expansion card and/or the power cables to the GPU card.Figure 60. Removing the filler bracketFigure 61. Installing an expansion cardNext steps1 Follow the procedure listed in After working inside your system.2 Install the expansion card holder.3 Install the air shroud.112 Installation and Service ManualInstalling and removing system components