Dell E30S002 Manual
                                                                                                                                                      |
Figure 27. Removing the drive from the drive carrierNext stepIf applicable, install the drive into the drive carrier.Related linkRemoving the front bezelInstalling a drive into the drive carrierInstalling a drive blankInstalling a drive into the drive carrierInstalling a drive into the drive carrierPrerequisitesFollow the safety guidelines listed in Safety instructions.CAUTION: Mixing drive carriers from other generations of PowerEdge servers is not supported.NOTE: When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.Steps1 Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.2 Align the screw holes on the drive with the screws holes on the drive carrier.When aligned correctly, the back of the drive is flush with the back of the drive carrier.3 Using the Phillips #1 screwdriver, secure the drive to the drive carrier with screws.Installation and Service ManualInstalling and removing system components75 |
Related manuals for Dell 4PM34
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine